Set Up: Sending data between a DF1 slave device and an EtherNet/IP™ Logix controller

Trying to modernize your DF1-based operation to one utilizing EtherNet/IP™? ProSoft Technology’s PLX51-DF1-MSG Messaging Module allows for a lower-risk, phased modernization of your DF1 equipment. In this video, you’ll learn how to set up the module’s Scheduled mode, setting up communications between a DF1 slave device and an EtherNet/IP Logix-based controller. Learn more about the DF1 module at http://psft.com/COQ.

You may also like

Demo: ProSoft Wireless Designer and IH Browser
15:53
Planning an industrial wireless network? You'll want to watch this ...
Webinar: The Future of Remote Networking
33:41
We’re setting up remote data transfers among three continents – you’ll ...
Set Up: PROFIBUS DPV1 Master/Slave Module for ControlLogix®
28:40
In this training video, we focus on setting up the new ILX56-PBM ...
Set Up: For AB Remote I/O to EtherNet/IP Flex I/O scanner
17:17
This video walks you through the process to setup ProSoft's ...
Groundbreaking Security and Safety feature for Remote Access
8:14
In this video, we’ll go over the process to enable and use a new ...
Set Up:  SMS Messaging with a Modicon M340 PLC
11:09
In this follow-up training video about ProSoft Technology’s ICX35-HWC ...
Set Up: For AB Remote I/O™ to EtherNet/IP™ drive migration gateway
18:21
This video teaches you how to setup ProSoft's AN-X2-AB-DHRIO gateway ...
Set Up: Upload and Download PLC programs from an EtherNet/IP™ PC to a DF1 PLC
7:29
Since Rockwell Automation® discontinued the 1761-NET-ENI, you may be ...
Set Up: DF1 master device polling an EtherNet/IP™ Logix controller
8:02
Trying to modernize your DF1-based operation to one utilizing ...

Page 1 of 10