Set Up: Multi-Point Wireless I/O System: Modbus® to I/O

Set Up: Multi-Point Wireless I/O System: Modbus® to I/O


Our Multi-Point Wireless I/O system lets you connect I/O to I/O, Modbus® serial to I/O, or Modbus serial to Modbus serial. This training video shows you how to configure the system to connect a Remote I/O device and a Modbus device to a control center, step by step. The systems can be deployed quickly, and let users avoid pulling wires, conduit, trenching, and permits. Find out more about ProSoft’s Wireless I/O systems at http://psft.com/BLC

You may also like

Demo: ProSoft Wireless Designer and IH Browser
15:53
Planning an industrial wireless network? You'll want to watch this ...
Webinar: The Future of Remote Networking
33:41
We’re setting up remote data transfers among three continents – you’ll ...
Set Up: PROFIBUS DPV1 Master/Slave Module for ControlLogix®
28:40
In this training video, we focus on setting up the new ILX56-PBM ...
Set Up: For AB Remote I/O to EtherNet/IP Flex I/O scanner
17:17
This video walks you through the process to setup ProSoft's ...
Groundbreaking Security and Safety feature for Remote Access
8:14
In this video, we’ll go over the process to enable and use a new ...
Set Up:  SMS Messaging with a Modicon M340 PLC
11:09
In this follow-up training video about ProSoft Technology’s ICX35-HWC ...
Set Up: For AB Remote I/O™ to EtherNet/IP™ drive migration gateway
18:21
This video teaches you how to setup ProSoft's AN-X2-AB-DHRIO gateway ...
Set Up: Upload and Download PLC programs from an EtherNet/IP™ PC to a DF1 PLC
7:29
Since Rockwell Automation® discontinued the 1761-NET-ENI, you may be ...

Page 1 of 10